 |
 |
 |
|
Our Thompson Center Contender mount is made specific to the gun, and will fit both rifles and pistols
Picatinny
cross slots run the full length of the rail, which gives the shooter
flexibility when mounting scope rings and other accessories. The channel
in the center reduces the overall mass of the mount, weighing in at
2-3oz on average.
Also, in many cases, it will not obstruct usage of
factory iron sights. EGW’s one piece scope mounts are the obvious
choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
EGW
machines these in their shop using one of our USA-made Fadal machining
centers. After machining, the mounts are tumbled, sand blasted, and Type
II anodized for long lasting durability.
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite.
Specifications:
- Machined from: Domestic 6061 T6 Extruded Aluminum
- Finish: Matte Black
- Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
- Center Spread: .838"
- Overall Length: 5.488"
- Height: 0.4"
Product Codes:
0 MOA - 46800
20 MOA - 46802
Due to different barrel types, the enclosed screws may need to be shortened.
⚠
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and reproductive harm. For more information go to: www.P65Warnings.ca.gov.
|
|
|
 |
|
 |
|
